How to remove and install the homogenizer mixing pump when pump ship to the destination port? Below are the tips to install Bonve high shear mixer.
1. Pump sent to area other than China will be packed in plywood case.
2. Users are advised to check the packing list, instruction manual, certificate of qualification, and other accessories attached after opening the wooden case.
3. Pump can be delivered to the installation site when the sealing bags at the inlet and outlet remain intact.
4. In hoisting, the hoist links at the pump body and the motor are available for use. If possible, users is better to carry the pumps with forklift trucks, handle with care.
5.The foundation of pump installation should have a horizontal plane. In line with the installation dimensions, four basic holes should be scooped first. Then ground screws are to be put into the holes for cement casting. When the cement is dry, use sizing block to adjust the chassis and make it horizontal. Lastly, screw up the ground bolts.
6. Pipe linking the pump should have supports respectively, which should not be the pump body.
7. To avoid damage to the pump's motor, install an overload current protection device during installation.
8. When the pump is installed, there should be a filter set ahead of the pump inlet. The filter screen should be 20 meshes or greater.
9. In installation, at pump inlet should be fixed a gauge valve for convenience of damaged meters replacement.
10. After the pump is installed, mark the ground connection point at the motor and make it connect the earth in accordance with the national safety standard.
11. If the pump is mobile type, hose should be used as at the inlet and outlet of the pump. In this case, valve and manometer are not necessary. The pump can only be pulled on level ground as four wheels (two of them are wheels) are fixed below the base plate. In case of too steep slope or a sharp turn, particular care should be taken to prevent any off-balance or sliding.
Click to view tips on installing Bonve rotary lobe pumps
